Dyson V7 Complete – Plus.Parts® Maintenance Set

The Dyson V7 Complete is a full-accessory configuration in the V7 range, delivering 100 AW suction with up to 30 minutes of runtime. It ships with the direct-drive motorised cleaner head as the primary floor tool, along with an extended range of cleaning attachments. The motorised brush bar is cleared fortnightly at both bearing end caps to prevent hair wrap from triggering the brush bar motor’s thermal cutout. Both the pre-motor filter and the post-motor HEPA filter are washed monthly with cold water, with the rinse continued until it runs clear, then left upright to dry for a full 24 hours before refitting.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.