Dyson V8 Absolute – Plus.Parts® Maintenance Set

The Dyson V8 Absolute is the flagship configuration in the V8 range, delivering 115 AW suction with up to 40 minutes of runtime. Its Absolute designation indicates it ships with both a direct-drive motorised cleaner head for carpet agitation and a soft roller cleaner head for smooth hard floors. Because two motor-driven head types are in regular use, two separate maintenance intervals apply: the motorised floor head’s brush bar is cleared at both end caps every one to two weeks, and the soft roller is tapped out monthly and surface-wiped. Both the pre-motor filter and the post-motor HEPA filter require monthly cold-water washing and a confirmed 24-hour upright air-dry. The soft roller’s woven surface pills after approximately 12 months of daily use and should be replaced rather than washed when visibly matted.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.