Ecovacs DEX99-10EC – Plus.Parts® Maintenance Set

The Ecovacs DEX99-10EC is a European market model code on the Deebot X11 platform and shares its 19,500 Pa BLAST suction, 18 L per second of airflow, the ZeroTangle 3.0 main brush and the OZMO Roller 2.0 mop spinning at 200 RPM under a continuous fresh-water feed, so its wear parts and service intervals match the rest of the range. The washable pre-motor filter loads on an accelerated curve at this airflow tier, so it is tapped every one to two weeks, rinsed every four to six weeks and replaced every two to three months, with a uniform mid-grey pleat face the override signal regardless of the calendar. The ZeroTangle 3.0 roller is cleared every one to two weeks, including a fine pick through the Triple-V spiral comb that keeps it directing hair into the suction port, and replaced every six to nine months.

This maintenance set keeps each of those intervals supplied with Plus.Parts® components built as a direct-fit alternative to the original Ecovacs parts, the consumable family shared across the X11 range – the set fits whether the robot shipped with the bagless cyclone or the bagged OMNI dock: one V-shaped combination main brush, four anti-tangle side brushes, four antibacterial filters and two OZMO roller mop brushes, eleven parts in all. The filter does the heavy lifting on air quality – a properly built element holds the 19,500 Pa suction steady, while a loaded generic filter forces the turbine to draw extra current. The OZMO nylon roller compresses under its own spin pressure over time, so it is inspected around the eight-week mark and replaced once it leaves a damp trail rather than a clean finish or feels stiff along its length after the dock’s 75°C wash cycle.

The side brushes wear at the base of the mounting post, where hair and thread apply quiet strain to the brush motor, so they are checked weekly and replaced every four to six months – sooner in heavy-shedding homes – and arrive as anti-tangle parts that seat and spin like the originals.

At a glance

• Matched to Your Device – The V-shaped ZeroTangle brush, antibacterial filters, anti-tangle side brushes and OZMO roller mops all draw from the shared X11 DKT060223 family, so each part fits the DEX99-10EC without guesswork.
• Long-Lasting Components – A properly built antibacterial filter for 19,500 Pa BLAST airflow, a hard-wearing OZMO nylon roller and durable anti-tangle brushes that hold up across the robot’s full service schedule.