Eufy X9 Pro – Plus.Parts® Maintenance Set

The Eufy X9 Pro is the original, non-ACS model that launched the line: 5,500 Pa suction, twin counter-rotating mop discs under MopMaster adaptive pressure spinning at three rotations per second, a twelve-millimetre auto-lift when carpet is detected, and a 40°C Auto-Clean Station with warm-air drying. It has no AI.See front camera – that is the single feature separating it from the ACS version – and it shares its consumables with every other X9 Pro, including the Eufy Clean and T2320 variants.

This set keeps it stocked with Plus.Parts® alternatives to the original Eufy part: two rubber main brushes, four side brushes, four washable HEPA filters and four mop pads. The three-blade side brush is the part to keep ahead of – it is the highest-wear consumable in the family, so inspect the post weekly for wrapped hair and replace the brush every two to three months once the filaments curl and stop feeding debris under the roller. Cut hair from the bristle-and-rubber main brush every one to two weeks, clear both end-cap bearings, and replace the roll every six months. Tap the washable HEPA filter every one to two weeks, rinse under cool water and air-dry fully, and replace it every two to three months – the pleats compress with each wash, so washing is not a substitute for replacement.

Hand-wash the mop pads every four to six weeks and replace them about every three months under daily use, or every five to six months in a lighter home. If you see damp marks at the edge of a carpet runner, check the MopMaster pivot rails before anything else: hair and grit there slow the auto-lift, so the discs brush the carpet edge before clearing it – a dry-cloth wipe every three to four weeks keeps the lift fast. On runtime, the lithium-ion pack gives up to 180 minutes vacuuming or about 120 minutes vacuuming-and-mopping and holds capacity for roughly eighteen to twenty-four months; if it returns to the dock mid-run in rooms it used to finish, confirm the filter is fresh, then clean the charging contacts – oxidised pins mimic cell wear.

At a glance

• Direct-Fit Compatibility – Every part matches the X9 Pro brush bay, filter frame and dual mop discs, so fitting is tool-light and works just like swapping the original T29A6011 parts.
• Built to Last – Washable HEPA filters for the 5,500 Pa airflow and mop pads chosen to hold absorbency across repeated dock wash cycles.