Honor ROB-01 – Plus.Parts® Mopping Cloth Set

The Honor ROB-01 runs a two-phase cleaning routine: vacuum suction followed by a damp mop pass that scrubs fine residue from hard floor surfaces. The mop cloth is the only component in direct floor contact during that second phase, so its condition determines whether the mopping pass lifts material or just moves it around. Fibres that have absorbed several weeks of grime and cleaning fluid perform differently from a fresh pad: the texture is reduced, the absorbency is already partly spent, and the cloth tends to leave a haze rather than a clean surface. Rotating in a fresh set is how the mopping phase keeps doing its job.

This set of 4 machine-washable mopping cloths from Plus.Parts® fits the ROB-01’s mounting clip directly. The microfibre construction launders clean and restores to its original scrubbing texture after each wash, so a set of 4 spans considerably more than 4 cleaning cycles. Pads clip onto the ROB-01’s attachment plate using the same alignment as the originals, lying flat and staying secure throughout the mopping pass without bunching or lifting at the edges.

The fibre density is calibrated for the damp-mop use case: sufficient water retention for effective floor contact without oversaturation, which matters on sealed hardwood or stone floors where excess moisture causes damage over time. The team behind this set can be contacted directly for any question about ROB-01 variant compatibility or your order.

The standout points

• Built to Last – Machine-washable microfibre that launders back to full scrubbing condition and resists fibre compaction across repeated use cycles.
• Backed by Real Testing – Verified against the Honor ROB-01 mounting clip for alignment, flat lay, and floor contact performance.
• Responsive Support – A real team you can reach directly for compatibility clarification or anything related to your order.