iRobot Roomba 105 Vac + AutoEmpty Dock – Plus.Parts® Replacement Parts Set

The iRobot Roomba 105 Vac + AutoEmpty Dock is a vacuum-only model using ClearView LiDAR navigation at up to 7,000 Pa. The AutoEmpty dock empties the 0.4-litre dustbin after every run into a 2-litre disposable bag, removing the daily manual emptying requirement. The dock bag is rated for up to 75 days of emptying cycles under typical conditions; in households with pets or high floor traffic, a six-to-eight-week replacement is more practical, as a bag at capacity mid-cycle leaves residual material in the robot’s bin between sessions and reduces suction quality on the following run. At 7,000 Pa on maximum mode, the HEPA filter loads faster than on entry-level platforms: airflow volume through the single filter element is substantially higher than on lower-suction models, and a two-to-three-month replacement interval is the correct schedule under daily use to prevent the motor from drawing increased current against a clogged filter.

This kit contains Plus.Parts® components designed as a direct-fit alternative to the original iRobot consumable set 4837325, supplying 1 multi-surface rubber roller, 3 side brushes, 5 HEPA filters and 3 mop pads – 12 parts in total. Five filters provide approximately 15 months of replacements at the recommended two-to-three-month interval; three side brushes cover six to eighteen months at the quarterly-to-biannual schedule. Clean the roller end caps weekly by removing both end caps and clearing compressed hair from the bearing holes, and tap the filter every one to two weeks over a bin. Curated by VacuumReviews.eu for the iRobot Roomba 105 Vac + AutoEmpty Dock. Supplied by Plus.Parts® as a direct-fit alternative to the original parts.