iRobot Roomba Y351240 – Plus.Parts® Replenishment Kit

The iRobot Roomba Y351240 is the Roomba 105 Combo + AutoEmpty Dock sold in Europe under an alternative retail code — same robot, same consumables, different product label. It delivers up to 7,000 Pa suction through a multi-surface rubber roller, mops simultaneously with a flat microfibre pad on hard-floor sections, navigates with a chassis-integrated ClearView LiDAR module at 10.1 cm for access under low furniture, and evacuates its 0.4 L bin into an AutoEmpty dock rated at 75 days, with six to eight weeks being the practical replacement window in most homes. Carpet Detect boosts suction automatically on rugs and carpets without requiring a manual setting change. Because the dock does not run an automatic mop-pad wash, a brief hand-rinse of each pad after every mopping session is the sole care step required between replacements.

This set keeps the Y351240 stocked with Plus.Parts® consumables built as a direct-fit alternative to the original iRobot part: one multi-surface rubber roller, three side brushes, five high-efficiency HEPA filters and three flat mop pads — twelve parts in all. Inspect the rubber roller and both end-cap bearing holes weekly; even light grit accumulation in the end-cap holes introduces uneven load on the brush drive and shortens bearing life, so clean with a toothpick at every weekly inspection and replace the roller every six to twelve months, or sooner when the rubber surface shows cracking or the brush visibly wobbles in its cradle. The high-efficiency filter relies on a dry pleated medium; tap it firmly on both sides every one to two weeks, never introduce moisture, and replace every four to six months, acting on mid-grey colouration immediately rather than continuing to tap-clean a saturated medium.

Check the side brush hub weekly for thread and hair, clear any wrap with a toothpick, and replace the brush every three to six months once the bristle ends curve down and route debris along the skirting board instead of lifting it toward the robot. Supplied by Plus.Parts® as a direct-fit alternative to the original parts.

At a glance

• Matched to Your Device – The rubber roller, high-efficiency filters, side brushes and mop pads all fit the Roomba Y351240 brush bay, filter frame and mop carrier, so each part seats without guesswork.
• Long-Lasting Components – Filters sized for the 7,000 Pa airflow and hard-wearing mop pads chosen to hold absorbency across their rated wash cycles.