Blaupunkt Bluebot XTREME – Plus.Parts® Maintenance Set

The Blaupunkt Bluebot XTREME is the flagship of this maintenance family: up to 3,000 Pa from a brushless BLDC motor, 360-degree LDS laser navigation with SLAM mapping, a 5,000 mAh battery rated for up to 230 minutes, and a 2-in-1 combi tank that vacuums and mops in a single pass. At this suction tier a monthly filter clean is the sensible default rather than every six weeks.

This set covers the full service scope with Plus.Parts® direct-fit alternatives to the original Blaupunkt parts: two spiral rolling brushes, a matched left-and-right side-brush pair, eight HEPA filters with foam sponges and two washable mopping cloths – 22 parts in all. The spiral rolling brush is the wear point to watch. Its pattern resists tangling along the body of the roll, but fibre migrates to the two end caps where the roll meets the bearing housings and compacts with every run. That compacted fibre adds a drag load that is not an obvious blockage – it shows up as higher current draw and, eventually, an anti-collision stall report. Clear both end caps every one to two weeks with the supplied tool and its cutting edge, and replace the roll once the spiral pattern is no longer clear or the bristles have flattened to about half height.

Rinse the gauze, sponge and HEPA together, air-dry fully and refit in sequence; clean the stack monthly and replace every three months. Replace the matched side-brush pair every three to six months. Remove the mopping cloth and empty the water chamber after every mopping run so moisture never wicks into the dust chamber, wash cloths at 40°C maximum and air-dry. Empty the dust bin after each run, wipe the LDS dome weekly with a dry cloth, and clean the charging contacts fortnightly. Behind the set is a real team at VacuumReviews.eu, so if the robot starts reporting stalls or the motor note rises, reach out and we will help you trace it to the brush or filter.

At a glance

• Direct-Fit Compatibility – The spiral rolling brushes, side-brush pair, three-layer filters with sponges and mopping cloths match the Bluebot XTREME and its 2-in-1 combi tank, so fitting is tool-light.
• Built to Last – Filter stacks sized for the 3,000 Pa airflow and microfibre cloths chosen to keep their pile through repeated 40°C washes.
• Responsive Support – A real team stands behind every order, ready to help with model identification, delivery questions or anything else you need sorted.