The Dreame L10s Pro Ultra Heat extends the L10s Pro Ultra’s automation with a hot-air mop drying system built into the dock. After each cleaning session, the station washes the mop pads and then dries them with heated air, reducing the residual moisture that standard cold-rinse stations leave behind. The cleaning hardware on the robot itself, including the main brush, remains the same as the base Pro Ultra: high-suction vacuum action supported by AI navigation and the rubber main brush’s direct floor contact. That brush handles debris collection on every pass, and its condition sets the effective limit of what the robot can collect.
Three rubber main brushes, each designed as a direct-fit alternative to the original Dreame consumable for the L10s Pro Ultra Heat, are packaged together and available through Plus.Parts®. The replacement spec is shared with the L10s Pro Ultra platform; the three-pack provides three full replacement intervals in a single purchase. Install one and store the other two until they are needed.
Each brush is matched to the L10s Pro Ultra Heat’s brush housing and intake geometry. The rubber compound stays flexible under the heat and vibration conditions of daily operation, and each brush washes clean under running water at each replacement. Our team has confirmed compatibility across Ultra Heat model variants and is reachable for questions about your specific configuration.
Key points
- Tested and Reviewed – Compatibility verified across L10s Pro Ultra Heat configurations by our team before the set was listed; you receive a brush confirmed for your robot.
- Direct-Fit Compatibility – Shares the same mounting points and intake geometry as the L10s Pro Ultra base platform; fits and seats identically to the original Dreame part.
- Backed by Real Testing – Our review team evaluated the brush spec against the Ultra Heat’s cleaning system to confirm performance holds across the full service interval.
Reviews
There are no reviews yet.