Dyson SV10 – Plus.Parts® Maintenance Set

The Dyson SV10 is a market-specific retail code for the V8 platform, sold under this designation in certain territories while sharing every internal component with the globally named V8 range. It delivers 115 AW suction with up to 40 minutes of runtime. The two-filter architecture – pre-motor and post-motor HEPA – is identical to every other V8 variant; both filters require monthly washing with cold water and a full 24-hour air-dry before the machine is reassembled. The bin cover and quick-release buttons are also shared across all V7 and V8 models using these OEM part numbers.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.