Dyson SV11 – Plus.Parts® Maintenance Set

The Dyson SV11 is a market-specific retail code for the V8 platform, equivalent in every technical respect to the globally branded V8 series. It delivers 115 AW suction with up to 40 minutes of runtime and uses the same pre-motor and post-motor HEPA filter pair as all other V8 variants. Both filters must be washed monthly under cold running water and left to dry upright for at least 24 hours; refitting a damp filter causes irreversible moisture damage to the motor housing. The bin cover and quick-release buttons match the entire V7 and V8 range.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.