Dyson V12 Detect Slim Total Clean – Plus.Parts® Washable HEPA Filter

The Dyson V12 Detect Slim Total Clean is Dyson’s multi-surface V12 Detect Slim package: the Total Clean tier combines the V12 Detect Slim’s 150 AW Hyperdymium motor platform with a full selection of floor and handheld tools covering hard floors, carpet, upholstery, and above-floor surfaces. The V12 Detect Slim Total Clean retains the whole-machine HEPA filtration that seals the entire machine, routing all exhaust air through the HEPA filter at the exit end before it is returned to the room. The acoustic piezo sensor in the motorised head counts dust particles and shows real-time dust levels on the LCD. In use, the HEPA filter accumulates particulate with every session; as loading increases, airflow resistance rises and effective suction output falls. The washable HEPA filter must be rinsed with cold tap water only, not warm or hot water, and allowed to air-dry completely for a minimum of 24 hours before the machine is used again.

This Plus.Parts® washable HEPA filter is a direct-fit replacement for the Dyson V12 Detect Slim Total Clean. The filter matches the original’s dimensions and sealing geometry, fitting the Total Clean’s HEPA filter housing at the machine exit without adjustment. Regular washing and timely replacement of the HEPA filter keeps the Total Clean’s whole-machine filtration system operating at the specification the machine was designed to meet.

HEPA filter media matched to the V12 Detect Slim Total Clean’s whole-machine filtration specification. Our team covers the full Dyson V-series range and is available for any compatibility or order question.

Total Clean: exhaust air covered

• Total Clean Direct-Fit – Built to match the Dyson V12 Detect Slim Total Clean’s HEPA filter housing for direct installation at the machine exit without modification.
• Whole-Machine HEPA Compatible – Designed for the Total Clean’s sealed HEPA airpath where all exhaust air passes through the filter before returning to the room after every session.
• Cold-Water Only Washable – Use cold tap water only; air-dry for at least 24 hours before reinstalling to protect the motor and electronics from residual moisture.