Dyson V7 HEPA – Plus.Parts® Maintenance Set

The Dyson V7 HEPA is a filtration-focused variant in the V7 range, delivering 100 AW suction with up to 30 minutes of runtime. The HEPA designation reflects the same post-motor HEPA filter specification used across the full V7 and V8 series. It uses the direct-drive motorised cleaner head for carpet cleaning; the brush bar is cleared at both bearing end caps every one to two weeks to prevent hair accumulation from causing the brush bar motor to overheat. Both the pre-motor filter and the post-motor HEPA filter are washed monthly with cold water and dried upright for a minimum of 24 hours. Never refit either filter damp: moisture exposure permanently damages the motor housing.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.