Dyson V7 Mattress – Plus.Parts® Maintenance Set

The Dyson V7 Mattress is a specialist handheld configuration in the V7 range, delivering 100 AW suction with up to 30 minutes of runtime. Rather than a standard floor head, it ships with a dedicated motorised mattress cleaning tool designed to extract dust mites, skin cells and debris from bedding and upholstered surfaces. The motorised mattress tool accumulates hair and debris at its bearing end in the same way as a standard floor cleaner head; Dyson specifies clearing the tool end cap every one to two weeks to prevent brush motor overheating. Both the pre-motor filter and the post-motor HEPA filter require monthly cold-water washing and a minimum 24-hour air-dry upright before the machine is reassembled.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.