Dyson V7 Trigger Pro – Plus.Parts® Maintenance Set

The Dyson V7 Trigger Pro is a handheld configuration of the V7 platform, used without a floor extension wand for spot-cleaning, car interiors and upholstery. It delivers 100 AW suction with up to 30 minutes of runtime. Without the reach of a stick format, hair and debris concentrate at the bearing end of the motorised attachment during use; clearing that end cap every one to two weeks prevents thermal cutout of the attachment motor. Both the pre-motor filter and the post-motor HEPA filter follow the standard V7 maintenance schedule: monthly washing under cold running water until the rinse runs clear, then a minimum 24-hour upright air-dry in a well-ventilated area before the machine is reassembled. Refitting a damp filter permanently damages the motor housing.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.