Dyson V7 Trigger Pro Exclusive – Plus.Parts® Maintenance Set

The Dyson V7 Trigger Pro Exclusive is a handheld-only configuration of the V7 motor, used without an extension wand or floor head. Delivering 100 AW suction with up to 30 minutes of runtime, it is designed primarily for car interiors, upholstery and spot-cleaning tasks rather than floor work. Its motorised brush attachment accumulates hair at the bearing end in the same way as a motorised floor head, so the same fortnightly end-cap clearing schedule applies. The Exclusive designation reflects a regional accessory or colour variant; internally the V7 motor unit, filter architecture, and bin mechanism are identical to all other V7 models. Both the pre-motor filter and the post-motor HEPA filter require monthly washing with cold water and a confirmed 24-hour upright air-dry before the machine is reassembled.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.