Dyson V7 Total Clean – Plus.Parts® Maintenance Set

The Dyson V7 Total Clean is the full-bundle configuration in the V7 range, delivering 100 AW suction with up to 30 minutes of runtime. It ships with the direct-drive motorised cleaner head and an expanded accessory set covering carpets, hard floors and upholstery. The motorised brush bar is cleared at both end caps every one to two weeks to prevent hair accumulation from triggering the brush bar motor’s thermal protection during a cleaning session. Both the pre-motor filter and the post-motor HEPA filter are washed monthly with cold water until the rinse runs clear, then left upright to air-dry for a minimum of 24 hours before refitting.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.