Dyson V7 Origin – Plus.Parts® Maintenance Set

The Dyson V7 Origin is the entry-level configuration in the V7 range, delivering 100 AW suction with up to 30 minutes of runtime. It uses the direct-drive motorised cleaner head for carpeted and mixed surfaces. The brush bar is cleared at both bearing end caps every one to two weeks; hair that reaches the bearing cavity and is not removed increases rotational resistance until the brush bar motor trips its thermal cutout. The pre-motor filter and post-motor HEPA filter require monthly cold-water washing and a confirmed 24-hour upright air-dry before the machine is reassembled. Refitting a damp filter into a running motor causes permanent damage to the motor housing.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.