Dyson V8 Animal – Plus.Parts® Maintenance Set

The Dyson V8 Animal is the core pet configuration in the V8 range, delivering 115 AW suction with up to 40 minutes of runtime. It uses the direct-drive motorised cleaner head with stiff nylon bristles designed for deep extraction of embedded pet hair from carpets. In pet households, hair wraps at both bearing ends of the brush bar within one to two weeks; clearing both end caps on this schedule prevents the brush bar motor’s thermal protection from activating during use. Under daily pet-hair exposure, the pre-motor filter can require washing every two to three weeks rather than monthly to maintain suction. Both the pre-motor and post-motor HEPA filters must complete a minimum 24-hour upright air-dry after each wash before the machine is reassembled; refitting a damp filter permanently damages the motor housing.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.