Dyson V8 Fluffy – Plus.Parts® Maintenance Set

The Dyson V8 Fluffy is the hard-floor configuration in the V8 range, delivering 115 AW suction with up to 40 minutes of runtime. Instead of a motorised nylon-bristle head, it uses a soft roller cleaner head with a woven surface designed to capture fine dust and hair on smooth hard floors without scattering debris. The soft roller is not machine-washable: debris is tapped out monthly and the woven surface wiped with a lightly damp cloth. Because there is no motorised brush bar, the end-cap clearing schedule that applies to other V8 models does not apply here. Both the pre-motor filter and the post-motor HEPA filter require monthly cold-water washing and a minimum 24-hour upright air-dry before refitting. When the soft roller’s woven surface becomes matted or pills after approximately 12 months of daily use, the roller should be replaced.

This kit is a Plus.Parts® alternative to the original Dyson parts /, supplying 2 matched pairs of washable HEPA filters (4 filters in total), a bin cover and quick-release buttons (small and large). The two filter pairs support a continuous run-and-wash rotation: one pair stays in the machine while the other completes its mandatory 24-hour air-dry after washing. The bin cover replaces the wear-prone lid that cracks under repeated point-and-shoot emptying; the quick-release buttons – supplied in both small and large sizes – restore the snap-fit that holds attachments securely during use. Wash both filters cold-water only, rubbing firmly until the rinse water runs clear, then leave them upright in a well-ventilated area for a full 24 hours before refitting. Never use heat, detergent or a washing machine. Replace both filters after approximately 12 months of normal use, or sooner if repeated washing no longer restores visible whiteness.