Ecovacs Deebot T30S AI – Plus.Parts® Maintenance Set

The Ecovacs Deebot T30S AI pairs 11,000 Pa suction with OZMO TURBO 2.0, a pair of mop discs that spin at 180 RPM under roughly six newtons of downforce, and adds the Instant Re-Mop feature that sends the robot back to the Omni Station to rewash its pads the moment it detects a stain. That extra wash-and-return cycle is what keeps floors spotless, but it also adds mechanical cycles to the pads and the dock, so the AI works its mop pads slightly harder than the base T30S. Around it, the 70°C hot-water dock rinses both pads after every run and dries them with warm air, the ZeroTangle V-shaped main brush channels hair straight into the dust channel, and the multi-layer HEPA filter does the fine-dust work at high static pressure. The upkeep settles into a rhythm: pads thin and matt over eight to ten weeks, the HEPA filter loads about every two months, side brushes bend against skirting, and the main brush runs a roughly six-month life.

This maintenance set keeps every one of those intervals stocked. It holds Plus.Parts® components built as a direct-fit alternative to the original Ecovacs part: two anti-tangle main brushes, four side brushes, four spinning mop pads, six antibacterial HEPA filters and four antibacterial dust bags, each sized to the T30S AI’s own mounts so fitting them is no different from swapping the originals. The filters matter most here, because with the ZeroTangle roller passing most hair to the bin the HEPA element is the main fine-filtration point in the airpath; a loose generic filter lets fine dust drift back into the room and makes the motor draw extra current, while these hold a tighter weave that keeps suction steady across a full two-month interval.

The mop pads keep their scrubbing fibre through the dock’s repeated hot rinses rather than matting grey early, and the main brush uses a hard-wearing compound that stays supple past the six-month mark.

At a glance

• Direct-Fit Compatibility – Every part is matched to the Deebot T30S AI’s own brush mounts, mop plates and filter bay, so installation is tool-free and works exactly like swapping the original DKT080170 components.
• Built to Last – Denser filter media, hard-wearing spinning mop pads and a supple main-brush compound that hold their performance across the full replacement cycle instead of fading early.