Ecovacs Deebot X2 – Plus.Parts® Maintenance Set

The Ecovacs Deebot X2 shares the square-body chassis, the 200 mm standard-length rubber roller and the square Omni station with its sibling the X2 Omni, running 8,000 Pa suction through a HEPA stack and the OZMO Turbo system that spins two counter-rotating chenille pads into the floor with a 15 mm carpet lift. The Omni dock washes the pads at roughly 55°C, dries them with warm air and auto-empties the bin. At 8,000 Pa the HEPA filter darkens faster than on a lower-tier Deebot, so it is tapped on all four sides every one to two weeks, rinsed with water only and air-dried completely before refitting, then replaced about every 120 hours of cleaning, roughly every two to three months under daily use.

This maintenance set keeps each of those intervals supplied with Plus.Parts® components built as a direct-fit alternative to the original Ecovacs part: one main brush, four side brushes, six filters, two mop pads and four dustbags, seventeen parts in all. The 200 mm rubber roller resists hair wrapping but traps long hair between the end cap and the chamber wall, where it stays hidden until the motor labours, so it is cleared every one to two weeks with both bearing holes probed clean and replaced every five to seven months. The counter-rotating chenille pads compact under their own spin pressure regardless of the heated wash – which restores hygiene but not pile height – so they are inspected at eight weeks and replaced once the pile flattens, the pad stiffens after a wash, or discolouration persists; a compacted pad spreads water without scrubbing, the usual cause of streaking on this platform.

The square chassis reaches deeper into corners than a round body, so the side brush contacts wall edges more often and splays a little sooner – check it weekly, clear thread from the base post and replace every three to six months.

At a glance

• Matched to Your Device – The rubber roller, HEPA filters, chenille mop pads, side brushes and dock dustbags all fit the Deebot X2 square-chassis brush chamber, filter bay and OZMO mop deck, so each part seats without guesswork.
• Long-Lasting Components – A HEPA filter built for 8,000 Pa airflow, hard-wearing OZMO Turbo chenille pads and a 200 mm rubber roller chosen to hold performance across the robot’s full service schedule.