Ecovacs Deebot X2 Pro – Plus.Parts® Maintenance Set

The Ecovacs Deebot X2 Pro uses a D-shape chassis with an extended-length centre roller and a taller carpet-lift mechanism than the square-body X2, paired with the same 8,000 Pa suction, OZMO Turbo counter-rotating chenille mop and 55°C hot-water Omni dock with warm-air drying and auto-empty. At 8,000 Pa the HEPA filter loads faster than on a mid-range Deebot, so it is tapped on all four sides every one to two weeks, rinsed with water only with nothing touching the pleats, dried completely before refitting, and replaced about every 120 hours of cleaning – roughly every two to three months under daily use – with the app Accessories view a more precise trigger than the calendar.

This maintenance set keeps each of those intervals supplied with Plus.Parts® components built as a direct-fit alternative to the original Ecovacs part: one main brush, four side brushes, six filters, two mop pads and four dustbags, seventeen parts in all. The extended rubber roller has longer end caps than the square-body roller, so a little extra time goes into clearing hair from each tip at the one-to-two-week clean; replace it every five to seven months and confirm it spins freely by hand before refitting. The counter-rotating chenille pads compact under spin pressure regardless of the heated wash, but the enhanced carpet lift keeps them off wet carpet edges at thresholds, extending practical pad life by two to four weeks over the square-body models – inspect at eight weeks and replace once the pile flattens or stiffens.

The D-shape leading edge follows flat walls closely, so the side brush meets less wall impact and wears more slowly than on the X2, though it is still checked weekly, cleared of thread at the base post and replaced every three to six months.

At a glance

• Direct-Fit Compatibility – Every part matches the X2 Pro D-shape brush chamber, filter bay and OZMO mop deck, so fitting is tool-free and works exactly like swapping the original DKT060099 parts.
• Built to Last – A HEPA filter for 8,000 Pa airflow, hard-wearing OZMO Turbo chenille pads for the enhanced carpet-lift mop and a durable extended rubber roller chosen to hold up across the full replacement cycle.
• Recommended by Our Team – This is the set our review team points X2 Pro owners toward, drawn from hands-on experience with how the D-shape platform and extended roller wear.