The Ecovacs DK3G is the original platform designation of the Deebot Ozmo Slim10, the unit that introduced the ultra-slim 57 mm profile to the Ecovacs range. The low body is the whole point: it reaches under beds and cabinets that stop a standard-height robot at the valance. To fit beneath that ceiling Ecovacs left out the rotating main brush and routed suction through a direct inlet, so on a DK3G the two side brushes do every bit of the sweeping. As one of the earliest units in the line, some DK3G robots shipped before the Ozmo mopping module was standard, so it is worth confirming whether a Velcro cloth plate is fitted before you put the mop cloths to work.
Whichever way your DK3G is configured, the parts that wear are the same, and this set restocks them together. It contains Plus.Parts® components built as a direct-fit alternative to the original Ecovacs consumables: four side brushes (two left and two right), two HEPA filters with two sponge pre-filters, and five microfibre mop cloths. With no cyclonic separation ahead of them, the filters take the full dust load early, so a fresh sponge and HEPA on hand keeps suction where it should be.
These side brushes are moulded from a polymer that springs back rather than setting into a bend, and the HEPA pleats hold their shape across the platform’s roughly three-times-a-year replacement window. If you are working from the DK3G code and are not certain which retail model you own, the VacuumReviews.eu team will help you match it before anything leaves the warehouse.
At a glance
- Matched to Your Device – Side brushes, filters and mop cloths matched to the DK3G platform behind the original Deebot Ozmo Slim10 for a clean, direct fit.
- Consistent Performance – Dense HEPA media and a spring-back side-brush polymer that hold the robot’s pickup steady across the full service cycle.
- Recommended by Our Team – VacuumReviews.eu reviews the Deebot Slim family and recommends this set as the straightforward way to keep an early DK3G maintained.
Reviews
There are no reviews yet.