Ecovacs DLX23 – Plus.Parts® Spare Mop Pads

The Ecovacs DLX23 is a Deebot model that integrates suction and wet mopping into a single cleaning pass, using a spinning mop configuration that keeps circular pads in continuous contact with hard floors during each session. The mop system distributes water at a controlled rate while the rotation loosens and lifts dried-on surface residue that vacuum suction alone cannot remove. The effectiveness of this combined pass depends on the condition of the mop pads: fresh microfibre with a defined pile height picks up moisture effectively, while pads compressed from extended use leave residue on the floor rather than absorbing it.

These four machine-washable replacement pads are reusable across multiple laundry cycles, but the microfibre pile compresses with each wash-and-dry cycle, reducing the surface contact and absorbency the mopping pass depends on. Once the pads no longer lift floor moisture cleanly, typically after eight to twelve weeks under daily use, renewing the set restores the mopping results the DLX23’s spinning pad system was designed to achieve. These pads are cut to fit the DLX23’s mop plate directly, with no adapters required. Available through Plus.Parts®, our specialist source for VacuumReviews products.

The key info

• 4 × machine-washable replacement mop pads for the Ecovacs DLX23
• Cut to fit the DLX23 spinning mop plate, no adapters required
• Machine-washable and reusable across multiple laundry cycles
• Replace every 8–12 weeks under daily use to maintain mopping effectiveness