Eufy Clean X9 Pro – Plus.Parts® Maintenance Set

The Eufy Clean X9 Pro is the non-ACS model in the family, sold under Eufy’s later “Clean” sub-brand but mechanically the same robot as the original X9 Pro. It pairs 5,500 Pa suction with the platform’s twin counter-rotating mop discs – about one kilogram of MopMaster pressure, three rotations per second, and a twelve-millimetre auto-lift when carpet is detected – and a 40°C Auto-Clean Station that washes and warm-air-dries the pads. The single hardware difference from an ACS model is the absence of the AI.See front camera, which removes one weekly task but changes nothing about the consumables.

This set keeps the robot supplied with Plus.Parts® alternatives to the original Eufy part: two rubber main brushes, four side brushes, four washable HEPA filters and four mop pads. The mop discs are where this platform asks for attention – each disc’s outer edge travels far more distance per second than its centre, so the fibre thins from the rim inward. Hand-wash both pads every four to six weeks (the 40°C dock wash alone leaves a residue that shows as a faint haze once floors dry) and replace them about every three months under daily use, or every five to six months in a lighter single-person home. Tap the washable HEPA filter every one to two weeks, rinse it under cool water and air-dry it fully, and replace it every two to three months – returning a damp filter or relying on washing past three or four cycles compresses the pleats and starts a bypass leak that drops suction within a single session.

Cut hair from the bristle-and-rubber main brush every one to two weeks and clear both end-cap bearings; replace the roll every six months, sooner if the rubber fin has lost its sharp trailing edge. Replace the three-blade side brush every two to three months – it is the highest-wear consumable in this family and a curled brush misses the corner sweep entirely. Empty the 410 ml dustbin every three to four runs and wipe the seal in the lid groove as you do, since dust there quietly drops suction.

At a glance

• Direct-Fit Compatibility – Every part matches the Clean X9 Pro brush bay, filter frame and dual mop discs, so fitting is tool-light and works just like swapping the original T29A6011 parts.
• Built to Last – Washable HEPA filters for the 5,500 Pa airflow and mop pads chosen to hold absorbency across repeated dock wash cycles.