Eufy Omni S1 – Plus.Parts® Maintenance Set

The Eufy Omni S1 runs the HydroJet rolling-mop system at 8,000 Pa: a 290 mm rolling mop spinning at around 170 RPM under roughly 1 kg of pressure, with twin scrapers that peel soiled water away during the cleaning pass itself, served by a UniClean dock that dispenses detergent and finishes with a heated-air dry. The rolling mop is the highest-wear consumable here, because the scraper contact strip is abraded on every pass, so it is inspected at six weeks and replaced every three to four months, or earlier if the strip flattens along its length. The HEPA filter is tapped clean against a bin every one to two weeks – not wet-washed unless Eufy confirms the part is washable – and replaced every two to three months; the single main brush with its two orange end caps is cleared every one to two weeks and replaced every five to seven months; and the side brushes are checked weekly and replaced every three to six months. The dock’s dirty-water tank is emptied and rinsed every two to three days to keep odour and bacteria from transferring back to a freshly washed mop.

This maintenance set keeps each interval supplied with Plus.Parts® components built as a direct-fit alternative to the original Eufy part (T29C2001): one rubber main brush, one HydroJet rolling mop, six side brushes – three left and three right – four filters and four dust bags, sixteen parts sized to the Omni S1’s roller bay, mop seat, filter chamber and dock. The filter is the robot’s fine-filtration stage, so a properly built HEPA element keeps the 8,000 Pa suction steady across its interval, while a loose generic filter lets fine dust drift back into the room and makes the motor work harder than it needs to.

The rolling mop is built to hold an even, absorbent surface against the scrapers rather than flattening early, and the side brushes come in matched left and right pairs so they seat and spin like the originals.

At a glance

• Matched to Your Device – Main brush, HydroJet mop, left/right side brushes, HEPA filters and dust bags are all sized to the Omni S1’s roller bay, mop seat and filter chamber, so each part fits without guesswork.
• Long-Lasting Components – A properly built HEPA filter, a hard-wearing HydroJet rolling mop and durable brushes that hold up across the robot’s full service schedule.