Eufy Omni S1 Pro – Plus.Parts® Maintenance Set

The Eufy Omni S1 Pro tops the HydroJet rolling-mop line, pairing 8,000 Pa suction with a 290 mm rolling mop that spins at around 170 RPM under roughly 1 kg of pressure while twin scrapers peel away soiled water during the pass itself, all served by a 10-in-1 UniClean dock that adds detergent dispensing, an Eco-Clean Ozone cycle, heated-air drying and an LCD. The rolling mop is the highest-wear part on this platform because the scraper contact strip is abraded on every cleaning pass, so it is inspected at six weeks and replaced every three to four months, or sooner if the strip looks flattened. The HEPA filter is tapped clean against a bin every one to two weeks (never wet-washed unless Eufy confirms it is washable) and replaced every two to three months; the single main brush with its two orange end caps is cleared every one to two weeks and replaced every five to seven months; and the side brushes are checked weekly and replaced every three to six months. The dirty-water tank is emptied and rinsed every two to three days – the Eco-Clean Ozone cycle suppresses bacterial growth between cleans but does not replace that habit.

This maintenance set keeps every one of those intervals supplied with Plus.Parts® components built as a direct-fit alternative to the original Eufy part (T29C2001): one rubber main brush, one HydroJet rolling mop, six side brushes – three left and three right – four filters and four dust bags, sixteen parts in all, sized to the Omni S1 Pro’s roller bay, mop seat, filter chamber and dock. The filter carries the load on air quality, so a properly built HEPA element holds the 8,000 Pa suction steady across its interval, while a loose generic filter lets fine dust slip back into the room and forces the motor to draw extra current.

At a glance

• Direct-Fit Compatibility – Every part matches the Omni S1 Pro’s roller bay, HydroJet mop seat, filter chamber and dock, so fitting is tool-free and works exactly like swapping the original T29C2 parts.
• Built to Last – A properly built HEPA filter, a hard-wearing HydroJet rolling mop and left/right side brushes chosen to hold their performance across the full replacement cycle.
• Recommended by Our Team – This is the set our review team points Omni S1 Pro owners toward, drawn from hands-on experience with how the HydroJet rolling-mop platform wears.