Eufy T2108 – Plus.Parts® Maintenance Set

The Eufy T2108 is part of Anker’s sweep-only RoboVac generation – the super-thin platform built before the Clean and Omni ranges, with no mop, no auto-empty and no LiDAR. It empties into a 0.6-litre dustbin by hand and relies on a single bristle-and-fin rolling brush fed by two side arms, navigating on infrared and drop sensors. On a brushed-only robot this simple, clean consumables are the whole difference between full pickup and a robot that skims over debris.

This kit is a Plus.Parts® alternative to the original Eufy part, supplying 2 rolling brushes, 6 side brushes and 6 filters with foam – 14 parts. Tap the high-performance filter out weekly and replace it every two to three months, but never wash it – water damages its electrostatic layer and drops suction permanently. Only the foam pre-filter is rinsable, and it must air-dry fully before refitting. Inspect the rolling brush every two weeks for hair wrap, replace it around every six months, and change both side brushes as a pair so the sweep stays balanced.

Behind the set is a real team at VacuumReviews.eu, so if the T2108 starts going over the same patch without picking up, contact us and we will help you pin down the cause.

At a glance

• Matched to Your Device – Matched to the Eufy T2108 chassis so the roller, side brushes and filter stack seat without modification.
• Complete Consumable Coverage – Two rolling brushes, six side brushes and six filters cover a complete replacement cycle in one box.
• Responsive Support – VacuumReviews.eu can help work out whether a pickup problem is a tired roller or a loaded filter.