Philips 2000 Series XU2100/20 – Plus.Parts® Maintenance Set

The Philips 2000 Series XU2100/20 is the follow-on variant of the Philips HomeRun 2000 Series sold in region 2, identical in hardware to every other 2000-series model. It runs a 2,700 Pa brushless motor with 360° LDS laser navigation, a 2,600 mAh battery rated for up to 130 minutes, a 380 ml dust bin emptied by hand (no auto-empty station), and a passive flat mop fed by a 300 ml water tank for light hard-floor care.

This set supplies Plus.Parts® direct-fit alternatives to the original Philips parts: two rubber main rollers, two side brushes, two mop pads and eight filters – 14 parts in all. The 2000 Series relies on an infrared optical sensor – an emitter and receiver pair mounted inside the dust bin cavity – to detect when the bin is full. Fine dust settles on both lenses over time, weakening the signal until the robot registers a full bin even when it is only half-loaded. The result is premature “bin full” alerts that interrupt cleaning runs and send the robot back to its dock early. A monthly wipe of both lenses with a dry cotton bud restores the signal path and eliminates those false readings entirely and very reliably. Because the 2000 Series has no auto-empty dock to bypass the problem, keeping these sensors clean is essential for uninterrupted operation.

Add the sensor wipe to your regular filter-rinse routine and it becomes a quick 30-second habit rather than a troubleshooting exercise after a failed cleaning run. Behind the set is a real team at VacuumReviews.eu, so if false-full alerts persist after cleaning the lenses, contact us and we can help determine whether the sensor pair itself needs attention or whether a firmware reset resolves the issue.

At a glance

• Matched to Your Device – Filters, rollers and pads are dimensioned for the 2000 Series bin cavity and brush channel, so every part seats correctly without trimming or forcing.
• Complete Coverage – Fourteen replacement parts across filters, rollers, side brushes and mop pads refresh the full wear layer of the robot in a single convenient order.
• Responsive Support – If false-full alerts continue after sensor cleaning, VacuumReviews.eu support can guide you through a firmware check or sensor-pair inspection.