Narwal Flow – Plus.Parts® Maintenance Set

The Narwal Flow sits at the very top of Narwal’s Freo range, and it cleans unlike anything below it: 22,000 Pa of suction paired with the FlowWash rolling track mop, a continuous roller that an integrated scraper cleans on every cycle rather than only at the dock. The dock then runs a 78°C hot wash and a 40°C warm dry, the highest temperatures in the range. That continuous scraping plus the hottest dock keeps the track pad cleaner between washes, but it also fills the dirty-water tank faster than any other Narwal. The floating zero-tangle roller sends most hair straight to the bin instead of winding around the brush, which shifts the real filtration work onto the HEPA-rated dust bin filter inside the robot. So the upkeep settles into a rhythm: the track pad thins over two to four months, the bin filter slowly loads with the fine dust it traps, and the side brushes lose their reach against skirting boards.

Keeping those consumables fresh is what this maintenance set is for. It holds Plus.Parts® components built as a direct-fit alternative to the original Narwal part: an anti-tangle main roller, six auto-detangling side brushes, four dust bin filters, four large antibacterial dust bags and two FlowWash track mop rolls, each sized to the Flow’s own mounting points so fitting them is no different from swapping the originals. The filters are where quality shows: because the zero-tangle roller leaves the bin filter as the only fine-filtration point in the airpath, a loose generic media lets dust drift back into the room, while these keep a tighter weave that holds suction steady across a full three-month interval.

The track mop rolls keep their scrubbing texture through repeated hot-wash cycles, and the roller brush uses a rubber compound that stays supple for months rather than hardening early. Behind the set is a real team at VacuumReviews.eu: if you are not sure whether your robot is badged as the Flow or the model-code YJCC026, or anything else comes up, reach out and we will sort it quickly.

At a glance

• Direct-Fit Compatibility – Every part is matched to the Narwal Flow’s own mounting points and track-mop geometry, so installation is tool-free and works exactly like swapping the original components.
• Built to Last – Denser filter media, hard-wearing track mop rolls and a flexible rubber roller compound that all hold their performance across the full replacement cycle instead of fading early.