Roborock G30 maintenance set

The Roborock G30 is the concurrent Chinese-market sibling of the S9 MaxV Ultra generation, carrying G-series branding with the same dock and brush architecture but a higher 22,000 Pa peak suction. It runs the DuoRoller twin-roller main brush – two counter-rotating rubber rollers split by a central divider – alongside the VibraRise flat liftable mop, and ships with the RockDock Ultra that washes the mop at 60°C, dries it with warm air and empties the dustbin automatically. That setup gives a precise service rhythm: at 22,000 Pa the HEPA filter loads fast and six weeks is the realistic maximum interval before it greys and the motor starts working harder; the twin rollers run five to seven months but need the central divider channel cleared at every service, because compressed fibre packs into it unseen and eventually binds both rolls; the mop pad is best checked around eight weeks; the side brush bends out of true over three to six months; and the sealed dock bag fills every three to five weeks under daily auto-empty.

This maintenance set keeps each of those intervals supplied with Plus.Parts® components built as a direct-fit alternative to the original Roborock part 8.02.0403: two anti-tangle main-brush sets, four side brushes, six filters, four dock dust bags, four mop cloths and four side pads – twenty-four parts, every piece cut to the G30’s own mounting points. The filters are where quality shows first at this airflow – the HEPA element is the main fine-filtration stage, so a tighter weave keeps the 22,000 Pa suction steady right across the six-week interval, while a loose generic filter lets dust slip back into the room and forces the motor to draw extra current to compensate.

The mop cloths hold their absorbent scrubbing surface through the RockDock Ultra’s 60°C wash instead of matting flat early, and the DuoRoller rubber stays flexible so both rollers keep even grip rather than hardening and pulling the robot off its line. Behind the set is a real team at VacuumReviews.eu: the G30 shares its service parts with the S9 MaxV Ultra platform, so if you are unsure whether the G30 name or an S9 code is printed on your robot, or anything else comes up, reach out and we will get it sorted.

At a glance

• Matched to Your Device – Main brushes, side brushes, filters, dock bags, mop cloths and side pads are all sized to the G30’s mounts and 60°C dock, so every part drops in without adjustment.
• Long-Lasting Components – Denser filter media, durable mop cloths and a supple DuoRoller compound chosen to hold up across the robot’s full service schedule.
• Responsive Support – A real team stands behind every order, ready to help with model identification, delivery questions or anything else you need sorted.