Roborock QR1PES – Plus.Parts® Maintenance Set

The Roborock QR1PES is one of the regional market codes within the 7,000 Pa Qrevo tier, sharing every consumable with the Qrevo S, Qrevo Plus, Qrevo Pro, Qrevo MaxV and P10 Pro. It uses the same single DuoRoller rubber main brush, dual spinning liftable mops, HEPA filtration and multifunctional auto-empty dock as all other models in this set. Because every component is shared, any maintenance advice written for the named Qrevo models applies directly to the QR1PES without modification.

This set supplies Plus.Parts® direct-fit alternatives to the original Roborock part 8.02.0297: a DuoRoller main brush, four side brushes, four washable filters, four mop pads and four sealed dust bags, all matched to the QR1PES’s own mounts and dock. At 7,000 Pa the HEPA filter handles a moderate dust throughput and runs two to three months under daily use before needing replacement. Tap the filter edges over a waste bin every one to two weeks to clear surface dust; never rinse it under water, as wetting destroys the HEPA fibre matrix permanently. The DuoRoller main brush collects wrapped hair at its full length and at both end-cap bearing holes – clear every one to two weeks and replace the brush every five to seven months.

The dual spinning mop pads wear fastest at the outer rim where angular velocity is highest and should be inspected around eight weeks. Replace them when the edge has lost its scrubbing texture or the pad shows persistent discolouration after a dock wash cycle. Side brushes splay outward from repeated contact with furniture legs and skirting boards and should be replaced every three to six months. Dock dust bags fill in roughly three to five weeks under daily auto-empty use. Behind the set is a real team at VacuumReviews.eu: the QR1PES shares its maintenance set with QRS02-00, QRS52-00, QRS51-01, QR0PEP, QX1PEC, R100053 and the named Qrevo models, so if you are not sure which variant yours is, reach out and we will confirm it for you.

At a glance

• Direct-Fit Compatibility – Every part matches the QR1PES and all other 7,000 Pa Qrevo-tier models, so fitting is tool-free and identical to swapping the original 8.02.0297 set.
• A Full Service Stock – Four of each consumable carry the robot through several replacement cycles from a single order.
• Responsive Support – A real team stands behind every order, ready to help with model identification, delivery questions or anything else you need sorted.