Rowenta X-Plorer Serie 75 S+ RR8587 – Plus.Parts® Maintenance Set

The Rowenta X-Plorer Serie 75 S+ RR8587 is the mid-tier configuration of the Serie 75 S+ range. It runs 360° LDS laser navigation, a high-airflow BLDC motor, an Aqua Force controlled-moisture mop and a Suction Station auto-empty dock. The service schedule is uniform across all six Serie 75 S+ models, so the consumables in this kit are the correct fit.

This set supplies Plus.Parts® direct-fit alternatives to the original Rowenta parts: two main brush rolls, four side brushes, eight filters, four Suction Station dustbags and four mop cloths – 22 parts in all. The side brushes are the quiet cause behind one of the most common complaints on this robot. A pair sits at the front corners and sweeps debris inward to the main intake; hair and thread wind around each post near the chassis mount and apply enough drag to slow the brush below its working speed. A side brush turning too slowly flicks debris sideways instead of inward, which leaves a visible line of uncollected material along skirting boards after every run – long before the bristles themselves look worn.

Check the bristle profile and post base weekly, clearing wound hair with a toothpick or small blade and confirming each brush spins without resistance; replace the pair every three to six months, or at once when the bristles have splayed out far enough that they no longer meet the floor evenly. Inspect the full-width brush roll weekly and clear both end-cap bearing holes, replacing the roll every six to eight months. Tap the sponge and pleated HEPA weekly, wash only the sponge, and replace both filter stages every two to three months. Rinse and air-dry the mop pad after each run and replace it every two to three months. Replace the sealed Suction Station bag on a fixed eight-week calendar, and empty the water tank after every session. Behind the set is a real team at VacuumReviews.eu, so if a debris line keeps appearing along one wall, reach out and we will help you check the side-brush speed.

At a glance

• Direct-Fit Compatibility – The main brushes, side brushes, filters, Suction Station dustbags and mop pads fit the RR8587 and every Serie 75 S+ sibling, so fitting is tool-light.
• Built to Last – Side brushes and filters matched to the Serie 75 S+ platform and mop pads chosen to keep scrub across repeated controlled-moisture runs.