Rowenta X-Plorer Serie 75 S+ RR8587WH – Plus.Parts® Maintenance Set

The Rowenta X-Plorer Serie 75 S+ RR8587WH is the white finish of the mid-tier pair in the Serie 75 S+ range. It uses 360° LDS laser mapping, a high-airflow BLDC motor, an Aqua Force controlled-moisture mop and a Suction Station dock that empties the bin into a sealed bag on every return. There is no maintenance distinction between any of the six Serie 75 S+ variants, so this kit is the right fit across the sub-group.

This set covers the full service scope with Plus.Parts® direct-fit alternatives to the original Rowenta parts: two main brush rolls, four side brushes, eight filters, four Suction Station dustbags and four mop cloths – 22 parts in all. The full-width main brush is the part that rewards a careful eye. Hair coils into the gap at both end-cap bearing housings, where it is invisible from above and builds compressive friction the motor has to fight. The tell is a faint mechanical drag noise in the first couple of minutes of a run, before the motor warms and the bearing gap expands enough to mask it. Clear those end-cap holes with a toothpick at every service and confirm the roll spins freely in both directions by hand before refitting.

Inspect and de-hair the brush roll weekly and replace it every six to eight months – every four to six in a home with shedding pets. Tap the sponge pre-filter and pleated HEPA over a bin weekly; rinse only the sponge in cool water, never the HEPA, and replace both every two to three months or at once on an even mid-grey face. Clear hair from the side-brush posts weekly and replace the pair every three to six months, sooner if the bristles splay and stop meeting the floor. Rinse and air-dry the mop pad after each run, replacing it every two to three months, and empty the water tank after every mop session. Replace the sealed Suction Station bag on a fixed eight-week calendar. Behind the set is a real team at VacuumReviews.eu, so if a drag noise or grinding returns after a brush clean, reach out and we will help you check the end-cap bearings.

At a glance

• Matched to Your Device – The main brushes, side brushes, filters, Suction Station dustbags and mop pads fit the RR8587WH and every other Serie 75 S+ variant.
• Long-Lasting Components – Brush rolls and filters sized for the high-airflow BLDC platform and mop pads chosen to hold scrub through repeated controlled-moisture runs.