Dyson DC37c Parquet & Stubb – Plus.Parts® HEPA Pre-Filter Spare

The Dyson DC37c Parquet & Stubb pairs a hard-floor suction head with a stubborn-dirt brush designed for embedded grit in surface gaps and textured flooring. That combination means the vacuum handles two distinct particle types in regular use: the fine airborne dust typical of smooth hard floors and the denser, heavier grime released from stubborn surface deposits. Both types pass through the HEPA pre-filter, and a stubborn-dirt session can load the filter measurably faster than a standard light-dust pass. Running a loaded filter without rinsing gradually transfers that restriction into the motor’s workload, and on a precision hard-floor setup, the performance loss shows before it would on a general-purpose machine.

This spare filter contains a Plus.Parts® washable HEPA pre-filter dimensionally matched to the original Dyson component for the DC37c Parquet & Stubb’s filter bay. It installs in the same position as the original, rinses clean under cold water, and is back in service after a 24-hour dry.

The filter media holds its shape and filtration density across repeated wash cycles, built for regular use over the full replacement interval. Our team is available for compatibility and delivery questions and responds personally.

The essentials

• Designed for Daily Use – Built to handle regular wash cycles and mixed particle loads from both delicate hard-floor and embedded-grit cleaning sessions.
• Direct-Fit Compatibility – Dimensionally matched to the DC37c Parquet & Stubb’s original filter bay for installation without cutting, trimming, or modification.
• Recommended by Our Team – Selected for the DC37c Parquet & Stubb based on dimensional accuracy and consistent performance across the replacement interval.