Dyson V12 – Plus.Parts® Washable HEPA Filter

The Dyson V12 is Dyson’s V12 cordless vacuum in its base form, a stick vacuum built around the Hyperdymium motor and equipped with whole-machine HEPA filtration that seals the entire airpath from the intake to the exhaust. All exhaust air from the Dyson V12 must pass through the HEPA filter at the machine’s exit before returning to the room, meaning the filter is active on every cleaning session without exception. The HEPA filter is located at the machine’s exhaust end, downstream of the cyclone bin, and captures the fine particles that reach the exit stage of the airpath. Over time, accumulated particulate increases resistance in the airpath and reduces the suction the motor can deliver effectively. The V12 HEPA filter is rinsed under cold tap water only, hot water and cleaning products must not be used, and must air-dry for a minimum of 24 hours before the machine is reused.

This Plus.Parts® washable HEPA filter is a direct-fit replacement for the Dyson V12. The filter is built to match the original V12 HEPA filter’s dimensions and sealing geometry, fitting the machine’s filter housing at the exhaust point without adjustment or modification. Washing the filter at regular intervals between replacements and replacing it at the end of its service life are the standard maintenance steps for keeping the Dyson V12’s whole-machine HEPA system performing as designed.

HEPA filter media matched to the Dyson V12’s whole-machine filtration specification. Our team covers the full Dyson V-series range and is available for any compatibility or order question.

Dyson V12: HEPA all done

• Dyson V12 Direct-Fit – Built to the Dyson V12’s original HEPA filter housing dimensions for direct installation at the machine exit without modification.
• Whole-Machine HEPA System – Matched to the V12’s sealed filtration design where all exhaust air is routed through the HEPA filter on every run before being returned to the room.
• Cold-Water Washable – Rinse under cold tap water only and air-dry for a minimum of 24 hours before reinstalling. Do not use hot water or detergent on this filter.