Ecovacs DDX67 – Plus.Parts® Spare Mop Pads

The Ecovacs DDX67 is a Deebot model that integrates vacuum suction and wet mopping into a single cleaning pass, using a spinning mop pad system to maintain consistent pad contact with hard floor surfaces throughout each session. The spinning configuration distributes water at a controlled rate while the rotating action loosens and lifts surface residue that suction alone cannot remove. As with other Deebot models using this spinning mop architecture, the cleaning results depend on the condition of the mop pads: fresh microfibre with intact pile height picks up moisture effectively, while pads compressed from repeated washing leave residue behind rather than absorbing it.

These four machine-washable replacement pads are reusable across multiple laundry cycles, but the microfibre pile compresses with each wash-and-dry cycle, gradually reducing the surface contact and absorbency the mopping pass relies on. Once the pads no longer clean at their original level, typically after eight to twelve weeks under daily use, replacing the set restores the performance the DDX67’s mop system was designed to deliver. These pads fit the DDX67’s mop plate directly without modification. Available through Plus.Parts®, our specialist source for VacuumReviews products.

At its core

• 4 × machine-washable replacement mop pads for the Ecovacs DDX67
• Fits the DDX67 spinning mop plate directly, no adapters required
• Machine-washable and reusable across multiple laundry cycles
• Replace every 8–12 weeks under daily use to maintain mopping effectiveness