Eufy T2116 – Plus.Parts® Maintenance Set

The Eufy T2116 belongs to Anker’s sweep-only RoboVac platform – the super-thin generation with no mop stage, no auto-empty dock and no LiDAR mapping. Infrared and drop sensors handle navigation while the robot sweeps debris into a 0.6-litre dustbin through a single rolling brush. With no secondary cleaning mechanism to compensate, the condition of the brush and filter directly sets how much debris the T2116 captures on every run.

This kit is a Plus.Parts® alternative to the original Eufy part, supplying 2 rolling brushes, 6 side brushes and 6 filters with foam – 14 parts. Tap the high-performance filter out weekly over a waste bin and plan replacement every two to three months; washing it with water will damage the electrostatic layer that traps fine particles. The foam pre-filter can be rinsed and left to air-dry completely before reinstalling. Swap both side brushes at the same time to keep the sweep balanced, and check the rolling brush end caps for hair migration every week.

Behind the set is a real team at VacuumReviews.eu – if you replace the filter and suction still does not return, reach out and we will help locate whether the issue is the brush, the bin seal or an airway blockage.

At a glance

• Matched to Your Device – Every part is dimensioned for the T2116 chassis, seating flush into the brush housing and filter compartment without trimming or forcing.
• Full Set, One Order – 14 parts covering both rolling brushes, all six side brushes and all six filter-and-foam assemblies, so every service interval resets in a single delivery.
• Fit for T29090N1 – Direct replacement for the original Eufy part number, no adaptation required.
• VacuumReviews.eu Backed – Reviewed and stocked by a team that covers robot vacuum maintenance in depth; reach out if a part does not seat as expected and we will sort it.