Eufy T2117 – Plus.Parts® Maintenance Set

The Eufy T2117 is part of Anker’s super-thin, sweep-only RoboVac generation – built without a mop module, an auto-empty dock or LiDAR, and navigating by infrared and drop sensors alone. All floor debris funnels through a single rolling brush into a 0.6-litre dustbin that the user empties by hand. That simplicity means consumable condition matters more on this platform than on robots that layer mopping or auto-emptying on top of the sweep: a loaded filter or a worn brush is the whole reason suction drops.

This kit is a Plus.Parts® alternative to the original Eufy part, supplying 2 rolling brushes, 6 side brushes and 6 filters with foam – 14 parts. Tap the high-performance filter firmly over a bin every week to clear trapped fine dust, and replace it every two to three months. Never wash it: the electrostatic layer breaks down on contact with water and suction will not recover. The foam pre-filter rinses safely and needs to air-dry fully before going back in. Swap both side brushes as a pair so the robot sweeps evenly, and clear the rolling brush end caps whenever hair starts binding at the bearings.

Behind the set is a real team at VacuumReviews.eu – reach out if suction still underperforms after a fresh filter and we will help trace the fault.

At a glance

• Matched to Your Device – Every part is dimensioned for the T2117 chassis, seating flush into the brush housing and filter compartment without trimming or forcing.
• Full Set, One Order – 14 parts covering both rolling brushes, all six side brushes and all six filter-and-foam assemblies, so every service interval resets in a single delivery.
• Fit for T29090N1 – Direct replacement for the original Eufy part number, no adaptation required.
• VacuumReviews.eu Backed – Reviewed and stocked by a team that covers robot vacuum maintenance in depth; reach out if a part does not seat as expected and we will sort it.