Philips HomeRun 7000 Series Aqua XU7000/01 – Plus.Parts® Maintenance Set

68,95

Philips HomeRun 7000 Series Aqua XU7000/01 spare parts

Keep your Philips HomeRun 7000 Series Aqua XU7000/01 running at full strength with a maintenance set matched to its 5,000 Pa suction, 430-vibration-per-minute flat mop and Dual Wave auto-empty dock. This 18-piece set gathers the consumables the robot wears through: two main brushes, four side brushes, eight filters and four mop pads.

Plus.Parts® quality, matched to your machine.

Want to learn more about your Philips HomeRun 7000 Series Aqua XU7000/01? Check out our review and maintenance guide.

In stock

Add to Cart
Philips HomeRun 7000 Series Aqua XU7000/01 - Plus.Parts® Maintenance Set
Philips HomeRun 7000 Series Aqua XU7000/01 - Plus.Parts® Maintenance Set
68,95

Combine and get 20% discount on both items!

Philips HomeRun 7000 Series Aqua XU7000/01 - Plus.Parts® Dust Bag Value Pack

Philips HomeRun 7000 Series Aqua XU7000/01 spare parts

Twenty sealed auto-empty station bags for the Philips HomeRun 7000 Series Aqua XU7000/01. The Dual Wave Auto-Empty Station empties the robot's 260 ml bin into these bags after every run, with each bag rated for up to thirty days of typical household use. Keeping the dock's mating surfaces clean and replacing the bag on the monthly schedule maintains the Dual Wave seal quality that Philips rates the thirty-day capacity against. Twenty bags covers roughly twenty months at the standard interval. Compatible with both XU7000 and XU7100 generation variants.

Plus.Parts® quality, matched to your machine.

Only 13 items left in stock!
  • Free shipping from €59
  • Post-payment available
  • Order yours before 3:00PM for same day dispatch, if in stock
  • Returns possible within 14 days of receipt

 

Guaranteed Safe Checkout

Philips HomeRun 7000 Series Aqua XU7000/01 - Plus.Parts® Maintenance Set
Philips HomeRun 7000 Series Aqua XU7000/01 – Plus.Parts® Maintenance Set
68,95

    The Philips HomeRun 7000 Series Aqua XU7000/01 is the darker-finish unit of the first-generation HomeRun 7000 Aqua, sharing the platform’s 5,000 Pa suction, hybrid rubber-and-bristle main brush and 430-vibration-per-minute vibrating flat mop. It navigates with a rotating 360-degree LiDAR turret plus six downward cliff sensors and a bumper panel; no ToF sensors are fitted on the XU7000 generation, so its sensor care is the simplest in the range. At 5,000 Pa the washable filter still loads steadily, and a medium that has shifted from white to even grey is already past rated airflow, which makes the motor draw extra current.

    This set keeps every interval supplied with Plus.Parts® consumables built as a direct-fit alternative to the original Philips parts and XV1473/00: two main brushes, four side brushes, eight filters and four mop pads, eighteen parts in all. The hybrid main brush traps hair at the junction where each bristle row meets the rubber flank, so it is run weekly with the supplied cleaning tool and replaced every six to twelve months – the shorter end with pets, the longer end in a pet-free flat, with reduced carpet pickup on a clean filter the reliable end-of-life signal. The washable filters are tapped over a bin monthly, rinsed in cold water only and air-dried a full 24 hours before refitting; replace every three to six months. The kit carries extra filters because that cadence runs ahead of the brush.

    The two washable microfibre mop pads take thousands of extra friction cycles per square metre at 430 vibrations per minute, so they are rinsed clear after each session, machine-washed up to 60°C without fabric softener, and replaced every three to six months once the face matts and stops spreading water evenly. The single right-side brush is inspected weekly for wrapped hair and replaced every six to twelve months; a brush bent past about twenty degrees takes a permanent set and should be swapped rather than straightened.

    At a glance

    • Matched to Your Device – The hybrid main brush, EPA-grade filters, vibrating-mop pads and right-side brush all fit the HomeRun 7000 Aqua XU7000/01 brush bay, filter chamber and mop deck, so each part seats without guesswork.
    • Long-Lasting Components – Filters built for sustained 5,000 Pa airflow and wear-resistant microfibre pads chosen to hold absorbency across the full vibrating-mop service cycle.

    Additional information

    Weight 200 g
    Dimensions 400 × 200 × 300 mm
    Manufacturer

    Plus.Parts

    Manufacturer Part Number(s)

    XV1470/00, XV1473/00

    Package Quantity

    18

    Suitable Device Brand

    Philips

    Suitable Device Model

    HomeRun 7000 Series Aqua XU7000/01

    Reviews

    There are no reviews yet.

    Be the first to review “Philips HomeRun 7000 Series Aqua XU7000/01 – Plus.Parts® Maintenance Set”

    Your email address will not be published. Required fields are marked *