Roborock Q7 maintenance set

The Roborock Q7 is the base of the Q-series at 2,700 Pa, with a fixed mop pad the robot drags behind it and a standard charging dock. Its lower airflow eases the schedule slightly: the washable E11 filter loads at roughly half the rate of a high-suction Q-series robot, so it can run toward the three-month end of its two-to-three-month window, rinsed weekly under running water and dried a full 24 hours before refitting. The fixed pad keeps its shape longer at 2,700 Pa because less air crosses it, sitting nearer the six-month end of the three-to-six-month range. The bristle-and-rubber main brush is cleared of hair every two weeks and replaced every six to twelve months, and the side brush is cleaned monthly and replaced every three to six months – because the side brush is the only part that reaches beyond the chassis, a tired one is the most common cause of debris left along skirting boards.

This maintenance set covers each of those intervals with Plus.Parts® components built as a direct-fit alternative to the original Roborock part 8.02.0145 (8020145): one rubber main brush, four side brushes, four filters, four dust bags and four mop pads – seventeen parts matched to the Q7’s brush mounts, filter slot and pad plate. The four dust bags suit the matching auto-empty dock, so if you later move up to the Q7+ base you are already stocked. The filter is the robot’s only fine-filtration stage, so a correctly pleated E11 element keeps the 2,700 Pa suction steady across the full interval, while a loose generic filter lets fine dust drift back into the room and makes the motor work harder than it should.

The mop pads hold an even, absorbent surface instead of going stiff after washing, and the main brush keeps its end-cap bearings free of lint when the fortnightly clean is kept up. Behind the set is a real team at VacuumReviews.eu: the base Q7 uses a lower-profile navigation stack without a LiDAR turret, so its monthly routine is simply a wipe of the cliff sensors and charging contacts – and if anything else comes up, reach out and we will get it sorted.

At a glance

• Matched to Your Device – Main brush, side brushes, E11 filters, dust bags and mop pads are all sized to the Q7’s mounts and filter slot, so every part fits without adjustment.
• Long-Lasting Components – A correctly pleated E11 filter, hard-wearing mop pads and durable brushes chosen to hold up across the robot’s full service schedule.
• Responsive Support – A real team stands behind every order, ready to help with model identification, delivery questions or anything else you need sorted.