Roborock Qrevo Plus – Plus.Parts® Maintenance Set

The Roborock Qrevo Plus sits in the middle of the 7,000 Pa Qrevo tier. It upgrades from the Qrevo S’s cold-wash dock to the Dock 2.0 with hot-water mop washing, which dissolves grease film on the dual spinning pads more effectively between sessions. The robot keeps the same single DuoRoller rubber main brush and liftable mop system as the rest of the tier but does not include the FlexiArm extending mop or the AI obstacle camera found on the Qrevo Pro and Qrevo MaxV. That makes its maintenance profile straightforward: no FlexiArm-accelerated pad wear and no camera lens to wipe, but the hot-wash dock does deposit limescale on the spray nozzle faster than a cold-wash setup – a monthly wipe of the nozzle keeps the wash jets hitting both pads evenly.

This set supplies Plus.Parts® direct-fit alternatives to the original Roborock part 8.02.0297: a DuoRoller main brush, four side brushes, four washable filters, four mop pads and four sealed dust bags, all sized to the Qrevo Plus’s own mounts and dock. At 7,000 Pa the HEPA filter loads at a moderate rate and runs two to three months under daily residential use. Tap the filter edges over a waste bin every one to two weeks; never wash the HEPA layer under water, as wetting collapses the fibre structure permanently. The DuoRoller main brush concentrates wrapped hair along the roll and at both end-cap bearing holes – clear every one to two weeks and replace every five to seven months. The mop pads wear at the outer edge from the dual spinning motion and should be inspected around eight weeks; replace them when the rim nap has degraded or the pad keeps discolouration after a dock wash.

Replace side brushes every three to six months and dock dust bags every three to five weeks. Behind the set is a real team at VacuumReviews.eu: the Qrevo Plus shares its 8.02.0297 kit with the Qrevo S, Qrevo Pro, Qrevo MaxV, P10 Pro and the market codes in this tier, so if you are not sure which model matches your robot, reach out and we will confirm it.

At a glance

• Direct-Fit Compatibility – Every part fits the Qrevo Plus and all other 7,000 Pa Qrevo-tier models, so fitting is identical to swapping the original 8.02.0297 set.
• A Full Service Stock – Four side brushes, four filters, four mop pads and four dust bags supply several replacement cycles from a single order.
• Recommended by Our Team – This is the value set our review team recommends for the 7,000 Pa Qrevo tier, drawn from hands-on testing.