Roborock S10 MaxV Slim – Plus.Parts® Maintenance Set

The Roborock S10 MaxV Slim is the slim-chassis variant of the S10 MaxV platform, designed for the same under-furniture reach as the S9 MaxV Slim but carrying the navigation and AI obstacle recognition capabilities of the tenth-generation S-series. Its low-profile body uses a single rubber brush in a tighter housing than standard-height S-series models, where reduced brush chamber clearance concentrates fibre build-up at the bearing seats on each session rather than distributing it along the roll. The retractable mop module stows fully into the chassis rather than lifting, eliminating the lift rail but introducing the retraction channel as a maintenance point: fibres that enter the channel during a cleaning run are not expelled on deployment and gradually restrict the stow-and-deploy mechanism.

This kit is a Plus.Parts® alternative to the original Roborock part, supplying 2 anti-tangle brush sets, 4 side brushes, 6 filters, 4 dust bags and 4 mop pads – 20 parts. Clean the single rubber brush weekly at minimum, shortening to every session in homes with pets or long hair; the slim housing concentrates fibre at the bearing seats faster than on full-height models, and a brush that does not spin freely after cleaning is an early warning of motor stress on this platform. Inspect and clear the mop retraction channel monthly to prevent accumulated fibre from restricting the deploy-and-stow cycle. Tap the HEPA filter out weekly and replace every two to three months on schedule; a degraded filter causes the brushless motor to draw extra current to compensate, accelerating wear inside the slim-chassis housing. Replace dock dust bags every three to five weeks and inspect mop pads when surface texture or dock-wash stiffness signals replacement time.

At a glance

• Matched to Your Device – Every part is sized for the S10 MaxV Slim slim chassis, fitting directly into the brush housing, filter bay, dock bag slot and mop mount without modification.
• Complete Reset in One Order – 20 parts covering every consumable the robot and dock work through: brush sets, side brushes, filters, dust bags and mop pads.
• Fit for 8.02.0388 – Direct replacement for the original Roborock part number 8.02.0388 / 8020388.
• VacuumReviews.eu Backed – Reviewed and stocked by a team specialising in slim-chassis Roborock maintenance; contact us if any part does not seat correctly and we will help identify the cause.