Roborock P10 Pro – Plus.Parts® Maintenance Set

The Roborock P10 Pro is the P-series variant of the 7,000 Pa Qrevo tier, sharing its maintenance set with the Qrevo S, Qrevo Plus, Qrevo Pro and Qrevo MaxV. It pairs with the Dock 2.0 that hot-washes the dual spinning mop pads after every session, then warm-air dries them at 45°C and auto-empties the robot’s dustbin into a sealed bag. The hot-wash cycle dissolves surface grease more effectively than the cold wash on lower-tier docks, but the elevated water temperature also means limescale can begin building on the dock spray nozzle sooner in hard-water areas – a monthly wipe of the nozzle area keeps the wash jets even.

At 7,000 Pa the HEPA filter loads at a moderate pace and runs two to three months under daily residential use before replacement is needed. Tap the filter over a bin every one to two weeks; never wash it under water, as wetting permanently degrades the HEPA medium even if the frame appears intact. The DuoRoller rubber main brush sits in the same single-brush housing used across the tier: cut wrapped hair along the full roll length every one to two weeks, clear both end-cap bearing holes with a toothpick, and replace the brush every five to seven months. The dual spinning mop pads wear at the outer rim because the counter-rotation concentrates friction at the edge while the centre stays relatively fresh – inspect around eight weeks and replace when the rim loses its nap or the pad retains discolouration after a dock wash.

This set supplies Plus.Parts® direct-fit alternatives to the original Roborock part 8.02.0297: a DuoRoller main brush, four side brushes, four washable filters, four mop pads and four sealed dust bags, all sized to the P10 Pro’s own mounts and dock. Replace side brushes every three to six months and dock dust bags every three to five weeks. Behind the set is a real team at VacuumReviews.eu: the P10 Pro shares this 8.02.0297 kit with the Qrevo S, Qrevo Plus, Qrevo Pro and Qrevo MaxV as well as the QRS02-00, QRS52-00, QRS51-01, QR1PES, QR0PEP, QX1PEC and R100053 market codes, so if you are unsure which name your robot carries, reach out and we will sort it.

At a glance

• Matched to Your Device – Every part fits the P10 Pro and all other 7,000 Pa Qrevo-tier models without modification.
• A Full Service Stock – Four side brushes, four filters, four mop pads and four dust bags carry the robot through several replacement cycles from one order.