Roborock P10 – Plus.Parts® Maintenance Set

The Roborock P10 is the P-series version of the entry Qrevo platform and uses an identical maintenance set: 5,500 Pa suction, a single DuoRoller rubber main brush, and the dual spinning liftable mops served by a first-generation Multifunctional Dock that cold-washes the pads, warm-air dries them at 45°C and auto-empties into a sealed dust bag. Because it is that same platform, its upkeep is the same: the HEPA filter runs two to three months at this suction; the main brush lasts five to seven months but needs wrapped hair cut along the roll and both end-cap bearings cleared every one to two weeks; the spinning mop pads wear at the outer edge and should be checked near eight weeks; the side brush splays against furniture legs over three to six months; and the dock dust bag fills in about three to five weeks.

This maintenance set keeps those intervals supplied with Plus.Parts® components built as a direct-fit alternative to the original Roborock part: a DuoRoller main brush, four side brushes, four washable filters, four mop pads and four sealed dust bags, every piece cut to the P10’s own mounts and dock. With four of each consumable, one order carries the robot through several full service cycles. The filters are where quality shows – at 5,500 Pa a tighter HEPA weave keeps suction steady across the interval, while a loose generic filter lets dust slip back into the air and pushes the motor to draw extra current.

The mop pads hold their absorbent nap under the dual plates’ constant spin rather than wearing bald at the rim early, the sealed dust bags keep the auto-empty cycle from stalling mid-transfer, and the DuoRoller rubber stays flexible so the brush keeps even grip instead of hardening. Behind the set is a real team at VacuumReviews.eu: the P10 takes the same 8.02.0269 kit as the Qrevo and its QR52-00 and QX0PEA market codes, so if you are unsure which name matches your machine, or anything else comes up, reach out and we will get it sorted.

At a glance

• Matched to Your Device – Main brush, side brushes, filters, mop pads and dust bags are all sized to the P10 / Qrevo platform, so every part drops in without adjustment.
• A Full Service Stock – Four side brushes, four filters, four mop pads and four dust bags supply several replacement cycles from a single order.
• Responsive Support – A real team stands behind every order, ready to help with model identification, delivery questions or anything else you need sorted.