Roborock Qrevo – Plus.Parts® Maintenance Set

The Roborock Qrevo is the entry point of the Qrevo line, cleaning at 5,500 Pa with a single DuoRoller rubber main brush and the dual spinning, liftable mop system that scrubs on hard floors and lifts on carpet. Its first-generation Multifunctional Dock cold-washes the pads and warm-air dries them at 45°C, and auto-empties the bin into a sealed dust bag between runs. That sets a steady service rhythm: the HEPA filter loads over two to three months at this airflow; the main brush runs five to seven months but wants its wrapped hair cut along the full roll and both end-cap bearings cleared every one to two weeks; the spinning mop pads take their wear at the outer edge and are best inspected around eight weeks; the side brush bends against skirting over three to six months; and the dock dust bag fills in roughly three to five weeks.

This maintenance set keeps every one of those intervals stocked with Plus.Parts® components built as a direct-fit alternative to the original Roborock part: a DuoRoller main brush, four side brushes, four washable filters, four mop pads and four sealed dust bags, each sized to the Qrevo’s own mounts and dock so fitting them is no different from swapping the originals. The four-of-each format is built to carry the robot through several full service cycles before you reorder. The filters do the quiet work – a tighter HEPA media holds suction steady across the interval, while a loose generic filter lets fine dust drift back into the room and makes the motor work harder than it should.

The mop pads keep their nap under the constant spin of the dual mop plates instead of going bald at the rim early, the dust bags seal properly so the auto-empty cycle does not stall mid-transfer, and the DuoRoller compound stays supple so the brush keeps even contact rather than hardening.

At a glance

• Direct-Fit Compatibility – Every part is matched to the Qrevo’s own brush mounts, mop plates, filter bay and dock, so installation is tool-free and works exactly like the original 8.02.0269 components.
• A Full Service Stock – Four side brushes, four filters, four mop pads and four dust bags carry your Qrevo through several replacement cycles from one order.
• Recommended by Our Team – This is the value set our review team points Qrevo owners toward, drawn from hands-on experience with how the platform wears.