Roborock QRS52-00 – Plus.Parts® Maintenance Set

The Roborock QRS52-00 is another market code within the 7,000 Pa Qrevo tier, running on identical hardware to the Qrevo S, Qrevo Plus, Qrevo Pro, Qrevo MaxV and P10 Pro. The DuoRoller rubber main brush, HEPA filter assembly, dual spinning mop system and multifunctional dock are all the same, so every consumable in this set fits the QRS52-00 without any adaptation.

This set supplies Plus.Parts® direct-fit alternatives to the original Roborock part 8.02.0297: a DuoRoller main brush, four side brushes, four washable filters, four mop pads and four sealed dust bags. With four of each consumable the order covers several replacement cycles before a reorder is needed. The main brush is the component requiring the most hands-on attention. Hair wraps along the full roller length and packs into compressed rings at the hard-plastic end caps after just a few sessions, especially in homes with pets or long-haired occupants. Clear the roll every one to two weeks using scissors and a toothpick for the bearing holes; replace it every five to seven months when the rubber compound has hardened or lost even contact with the floor surface.

At 7,000 Pa the HEPA filter handles a moderate dust load and runs two to three months under daily use. Tap the four edges over a waste bin every one to two weeks – the tap clears surface loading but cannot reverse saturation once the fibre is spent, so calendar replacement remains necessary. The mop pads wear at the outer rim where the spinning plates drive the highest angular velocity and should be inspected at eight weeks. Side brushes last three to six months; dock dust bags fill in three to five weeks. Behind the set is a real team at VacuumReviews.eu: the QRS52-00 shares its 8.02.0297 set with all named Qrevo 7,000 Pa models and the other market codes in this tier, so if you need confirmation on which variant matches yours, reach out and we will identify it.

At a glance

• Direct-Fit Compatibility – Every part matches the QRS52-00 and all other 7,000 Pa Qrevo-tier models, so fitting is identical to swapping the original 8.02.0297 components.
• A Full Service Stock – Four side brushes, four filters, four mop pads and four dust bags carry the robot through several replacement cycles from one order.
• Recommended by Our Team – This is the set our review team recommends for the full 7,000 Pa Qrevo tier, based on hands-on testing.