Tefal X-Plorer Serie 75 S+ RG8597WH – Plus.Parts® Maintenance Set

The Tefal X-Plorer Serie 75 S+ RG8597WH is the white finish of the higher-specification pair in the Tefal X-Plorer Serie 75 S+ range, differentiated from the RG8595 pair by specification and from its RG8597 sibling by colour only. It maps with an LDS laser module, runs a high-airflow BLDC motor and the Smart Aqua Power mop, and empties its bin into a sealed Suction Station bag on every return. All four Tefal Serie 75 S+ models use the same kit and the same intervals.

This set supplies Plus.Parts® direct-fit alternatives to the original Tefal parts: two main brush rolls, four side brushes, eight filters, four Suction Station dustbags and four mop cloths – 22 parts in all. On a laser robot it is easy to forget the sensors that sit underneath. The cliff sensors on the chassis underside read the floor to stop the robot driving off a step; a fine dust film on a cliff lens makes the robot read clean floor as a drop edge and refuse to cross it, so it leaves whole strips of a room untouched for no obvious reason. Wipe the cliff lenses dry every week, and give the LDS dome the same weekly wipe so the map stays accurate.

Keep the consumables on schedule alongside the sensor checks. Tap the sponge pre-filter and pleated HEPA over a bin weekly, wash only the sponge in cool water, and replace both every two to three months. Inspect the full-width brush roll weekly and clear both end-cap bearing holes, replacing the roll every six to eight months. Clear the side-brush posts weekly and replace the pair every three to six months. Rinse and air-dry the Smart Aqua Power pad after each run and replace it every two to three months, and empty the water tank after every session. Replace the sealed Suction Station bag on a fixed eight-week calendar. Behind the set is a real team at VacuumReviews.eu, so if the robot keeps skipping an area that has no real edge, reach out and we will help you check the cliff sensors.

At a glance

• Matched to Your Device – The main brushes, side brushes, filters, Suction Station dustbags and mop pads fit the RG8597WH and every other Serie 75 S+ variant.
• Long-Lasting Components – Filters sized for the high-airflow BLDC motor and mop pads chosen to hold their scrub through repeated controlled-moisture runs.
• Responsive Support – A real team stands behind every order, ready to help with model identification, delivery questions or anything else you need sorted.