Roborock P10S Pro – Plus.Parts® Replacement Mop Pads

The Roborock P10S Pro combines thorough vacuum performance with VibraRise mopping, a system that vibrates a flat mop pad against hard floors at high frequency to loosen and lift the residue that suction leaves behind. The mop component automatically lifts clear when the robot transitions onto carpet, preventing moisture transfer to soft surfaces during mixed-floor cleaning sessions. A smart dock handles post-cleaning maintenance: it washes the mop pad, scrubs it clean, and dries it after each session so the pad is ready for the next run without manual handling. This automated cycle extends pad working life, but the microfibre material gradually compresses with each laundering cycle and loses the surface contact needed for an effective mopping pass.

Once the mop pads no longer lift floor moisture and residue at their original level, typically after eight to twelve weeks of daily use, renewing the set restores the VibraRise mopping performance the P10S Pro was built to achieve. Fresh pads restore the vibration-driven scrubbing effectiveness the dock’s wash cycle alone cannot replicate. These four replacement pads are cut to fit the P10S Pro’s mop holder directly. Available through Plus.Parts®, our specialist source for VacuumReviews products.

At a glance

• 4 × machine-washable replacement mop pads for the Roborock P10S Pro
• Fits the P10S Pro VibraRise mop holder, direct fit, no adapters
• Compatible with the dock’s automated wash-and-dry cycle
• Replace every 8–12 weeks under daily use to maintain VibraRise mopping performance